FITTING INSTRUCTIONS FOR
AH ASTRA BONNET PROTECTOR
FD1250
30SEP04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Page 1 of 2
TOOLS REQUIRED:
Alcohol Wipes (supplied), Clean Shop Rag.
FITTING INSTRUCTIONS:
NOTE: It is recommended that the vehicle is washed
and allowed to dry before commencing fitment of the
bonnet protector.
1. If the rubber edge seal (1) is fitted, remove and place in
the luggage compartment. Refer to Figure 1.
Refer to Figure 2 for the following:
2. Open and clean the bonnet. Trial fit the bonnet protector
(1) centrally onto the bonnet (2).
3. Note the holes in the bonnet protector tags (3) that
correspond to the underside of the bonnet.
4. Remove the bonnet protector.
FIGURE 2
1
3
333
2
Part No. 92148339
FIGURE 1
11
FITTING INSTRUCTIONS FOR
AH ASTRA BONNET PROTECTOR
FD1250
30SEP04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Page 2 of 2
FIGURE 4
FITTING INSTRUCTIONS: - continued...
Refer to Figure 3 for the following:
5. At the previously noted positions, clean these areas with
the alcohol wipe provided (1) and remove any residue
with a dry clean cloth. Refer to Figure 3.
6. Apply abrasive resistant tape (2), to the underside of the
bonnet, so that approximately half of each strip is
adhered to the topside and half adhered to the
underside of bonnet. Refer to Figure 4.
7. Refit the bonnet protector (1) and secure it to the
bonnet (2) with the metal clips (3) provided. Ensure
that the barb in the clip snaps into the hole in the
bonnet protector. Refer to Figure 5.
8. Place the fitting instructions in the glovebox for future
use.
FIGURE 5
3
1
3
1
2
2
FIGURE 3
PARTS LIST
PART NUMBER DESCRIPTION QUANTITY
92148330 BONNET PROTECTOR KIT 1
BONNET PROTECTOR 1
CLIP 4
ABRASIVE RESISTANT TAPE 4
FD1250 FITTING INSTRUCTIONS 1
FD796 PROOF OF WARRANTY CARD 1