FITTING INSTRUCTIONS FOR
AH ASTRA REAR SPOILER
FD1300
07OCT04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Page 1 of 2
TOOLS REQUIRED:
Caulking Gun, Clean Shop Rag, Cleaning Solvent, Felt-tip
Pen, Masking Tape, Polyurethane Adhesive and Primer.
FITTING INSTRUCTIONS:
Refer to Figure 1 for the following:
1. The raw rear spoiler (1) is supplied primed ready for
painting. Prior to painting, mask out the adhesive
grooves. The rear spoiler should be painted the vehicle
body colour.
NOTE:
Refer to the Service Information for correct painting
preparation and application procedures.
The paint code for the vehicle can be found on the body
option identification plate. The paint code enables
refinish paint to be matched with the original paint colour.
The paint may not exactly match the original colour due
to fade, in which case paint colour matching will be
required. As this is an acquired skill, it is a task that must
be performed by qualified individuals.
Part No. 92148997
FIGURE 1
1
FITTING INSTRUCTIONS FOR
AH ASTRA REAR SPOILER
FD1300
07OCT04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
2
1
1
PARTS LIST
PART NUMBER DESCRIPTION QUANTITY
92148997 REAR SPOLIER KIT 1
REAR SPOILER 1
93183413 AERIAL ADAPTER 1
FD1300 FITTING INSTRUCTIONS 1
FD796 PROOF OF WARRANTY CARD 1
FIGURE 2
FIGURE 3
FIGURE 4
FITTING INSTRUCTIONS: - continued...
2. Dry fit the spoiler to the vehicle to ensure part has no
distortions and will fit correctly. (Refer figure 2)
3. Using a felt-tipped pen, mark the position of the rear
spoiler to allow for correct alignment when bonding.
Refer to Figure 3 for the following:
NOTE: Refer to adhesive supplier instructions for
bonding requirements.
4. Apply polyurethane primer to the rear spoiler and the
vehicle body at the adhesive contact positions.
5. Apply polyurethane adhesive (1) to the grooves on the
upper edge of the rear spoiler.
6. Pull the adhesive tape backing back 50mm and fold out
(6 places).
7. Carefully position the spoiler and apply light pressure
around the perimeter to position the spoiler.
8. Remove the adhesive tape backing and press the
spoiler into position.
9. Using the cleaning solvent and rag, remove all fitting
marks and excess adhesive.
Refer to Figure 3 for the following:
10. Apply masking tape to hold the rear spoiler in position
during curing of the adhesive.
11. Allow at least 12 hours for the adhesive to cure before
driving the vehicle.
12. Remove the aerial. Install the aerial adapter and the
aerial.
13. Place the fitting instructions in the glovebox.