FITTING INSTRUCTIONS
1. Remove head restraint assembly and 'elevate' seat to highest position.
2. Insert head restraint mounting assembly through 2 holes in front seat insert upper.
3. Fit head restraint and front seat insert to backrest. Refer View A.
4. Feed the fastening buckles between seat and backrest. Fit seat section into position ensuring to
tuck 20 to 30mm in between seat and backrest. Refer Section A-A (page 2).
5. Feed the front fastening buckles under the seat, above and over all adjustments and wiring
assemblies. Refer View B (page 2).
6. Fasten buckles and tension by pulling loose end of fastening strap. Tuck excess tape out of sight.
7. Some periodic adjustment and re-tensioning may be required to maintain the best fit.
NOTE: If adjusting the seat cushion length (Vectra) remember to loosen the fastening tapes first.
WASHING INSTRUCTIONS
Dry cleaning recommended.
Hand wash with approved wool detergents. Do not soak for prolonged periods.
Rinse and gentle spin (fleece out) dry away from direct heat, preferably flat in shaded area.
While still damp, gently pull into shape and brush with a coarse stiff brush to restore pile.
FITTING INSTRUCTIONS FOR
ZC VECTRA & TF3 RODEO FRONT SEAT INSERT
Part No. 92145321
FD1124
29JA03
COPYRIGHT
Page 1 of 2
G761
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
FITTING INSTRUCTIONS FOR
ZC VECTRA & TF3 RODEO
FRONT SEAT INSERT
Page 2 of 2
G761
HOLDEN SERVICE PARTS OPERATIONS
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
A
B
ROUTE FASTENING CLIPS
UNDER THE SEAT, ABOVE
ALL MECHANISMS AND
WIRING ASSEMBLIES
A-A
BACKREST
SEAT
CUSHION
SEAT
INSERT
TUCK 20-30mm OF SEAT
INSERT IN BETWEEN SEAT
CUSHION AND SEAT BACK
FRONT
A
B
A
A
FRONT SEAT
INSERT UPPER
FD1124
29JA03