
FITTING INSTRUCTIONS FOR
RA RODEO TONNEAU COVER
- PROTECTIVE TAPE KIT
FD1288
07SE04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
TOOLS REQUIRED:
Hi-tech cleaning pads (supplied).
For tub liner removal: Phillips Head Screwdriver, 10mm
Socket, Extension, Rachet, T40 Torx Bit, Allen Key 5 mm.
FITTING INSTRUCTIONS:
NOTE: It is recommended that the vehicle is cleaned
before starting the procedure and any paint repairs are
performed and allowed to cure.
Refer to Figure 1 for the following:
1. Remove the tonneau cover (1), if fitted.
2. Remove the tub liner and the tailgate liner, if fitted.
3. Use the hi-tech cleaning pad (1) (supplied) to clean the
side of the vehicle above the tie-down positions where
the liner contacts the vehicle body. Refer to Figure 2.
4. Remove the backing with writing on (1) from the
patch (2). Leave the covering on the patch. Refer to
Figure 3.
5. Position the patch (1) vertically above the tie-down point
so that it straddles the upper body contour line and the
top of the tray. Refer to Figure 4.
NOTE: The centre of the patch should coincide with the
corresponding bungy hard fixing point on the tonneau
cover.
Page 1 of 2
Part No. 92148810
FIGURE 1
FIGURE 2
FIGURE 4
FIGURE 3
1
1
2
1
1