FD895
25NO98
COPYRIGHT
Page 1 of 2
FITTING INSTRUCTIONS FOR
JS VECTRA HATCH BACK
REAR WINDOW BLIND
Part Number: 92141478
G80-H1
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
TOOLS REQUIRED:
- PHILLIPS HEAD SCREWDRIVER
- POWER DRILL
- 4.0MM DRILL BIT FOR DRILLING
PARCEL SHELF
DESCRIPTION QUANTITY
BLIND, REAR WINDOW 1
SCREW 4
WASHER 4
NUT 4
HOOK, REAR BLIND 2
SCREW, SELF TAPPING 2
NUTSERT, PLASTIC 2
PARTS LIST
Page 2 of 2
FD895
25NO98
G80-H2
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
COPYRIGHT
1. Remove rear parcel shelf from vehicle and place
upside down.
2. Place rear window blind adjacent to front edge of
centre pivot bosses.
3. Use blind as a template to mark mounting hole
locations.
4. Remove blind and drill 4.0mm dia. holes, 4 places.
5. Attach blind to upper surface of parcel shelf using
screws, washers and nuts supplied in package.
NOTE: Blind assembly must be fitted so retractable
blinds are easily withdrawn towards front of vehicle.
Be sure slots in tube favour a frontal position, refer
Figure 2.
6. Remove 3 headlining trim fasteners from above rear
window.
7. Pull rear edge of headlining away from roof to
enable nutserts to be installed. Insert plastic
nutserts to two outboard holes in sheet metal, where
headlining fasteners were removed.
IMPORTANT: Nutserts must be installed with slot
horizontal, so nutsert is firm in hole once installed.
8. Refit headlining trim fastener to centre hole.
9. Attach two hooks to nutsert locations using screws
supplied in package.
10. Refit parcel shelf.
C
L
NUT
(2 PLACES
EACH SIDE)
WASHER
(2 PLACES
EACH SIDE)
SCREW
(2 PLACES
EACH SIDE)
REAR WINDOW BLIND
REAR PARCEL SHELF
FIGURE 3
FIGURE 1
FIGURE 4
DRILL
4.0 DIA.
HOLE
(2 PLACES
EACH SIDE)
NUTSERT
(2 PLACES)
SELF TAPPING SCREW
(2 PLACES)
FIGURE 2
REMOVE
HEADLINING
TRIM FASTENER
(3 PLACES)
PLACE REAR WINDOW BLIND
AGAINST FRONT EDGE OF
CENTRE PIVOT BOSSES
AND MARK MOUNTING
HOLE LOCATIONS
(4 PLACES)
UNDERSIDE OF
PARCEL SHELF
CENTRE
PIVOT
BOSS
CENTRE
PIVOT
BOSS
PLASTIC HOOK
(2 PLACES)
HEADLINING TRIM
REFIT CENTRE
FASTENER