FD944
16SE99
COPYRIGHT
Page 1 of 1
FITTING INSTRUCTIONS FOR
JR/JS VECTRA FRONT SEAT COVERS
Part Number 92143275
FD944-1
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
SAFETY NOTICE
Seat covers NOT suitable for vehicles with Side
Impact Air Bag Protection
Feed front fastening clips under the seat,
above and over all adjustment and wiring
assemblies.
FITTING INSTRUCTIONS
1. Remove headrest assembly and 'elevate'
seat to highest position.
2. Locate seat cover headrest opening and
position underneath headrest mounting
assembly. Firmly and squarely pull backrest
section down into position.
3. Feed fastening buckles through between
seat and backrest. Fit seat section into
position ensuring to tuck 20 to 30mm in
between seat and backrest. Reshape as
necessary.
4.
5. Use wire hook supplied to feed door side
seat loop between plastic seat trim and seat
assembly to rear of seat, ensuring to clear all
belt and seat adjustments.
6. From rear of seat locate and feed 'right hand
side' backrest and seat loops. Connect
diagonally opposite to 'left hand side'
fastening clip then tension by pulling loose
end of fastening strap. Repeat for 'left hand
side' fastening buckle and clip.
7. Fit headrest cover section squarely and firmly
into position. Fasten ties and tuck in excess
tape out of sight. Replace head rest
assembly.
8. Some adjustment and re-tensioning may be
required to achieve the best fit.
WASHING INSTRUCTIONS
Hand wash with approved wool detergents.
Do not soak for prolonged periods.
Rinse and gentle spin (fleece out) dry away from
direct heat, preferably flat in shaded area.
While still damp, gently pull into shape and brush
with a coarse stiff brush to restore pile.
Dry cleaning recommended.
BACKREST
LOOP
SEAT LOOP
FASTENING CLIP
FASTENING BUCKLE
ROUTE FASTENING CLIPS
UNDER THE SEAT, ABOVE
ALL MECHANISMS AND
WIRING ASSEMBLIES
TIE COVER
TO HEADREST
AND NEATLY
TUCK TIES
UNDER COVER
FRONT