
FITTING INSTRUCTIONS FOR
RA RODEO & VZ COMMODORE
LAMBS WOOL SEAT INSERT & COVER
FD1214
12AUG04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Page 5 of 6
FIGURE 4
FIGURE 5
FITTING INSTRUCTIONS: - continued...
16. For Rodeo vehicles only, open the Velcro strip and pass
the seatbelt buckle through the hole in the seat cover.
Refer to Figure 3.
NOTE: For Commodore, leave seatbelt buckle outside
the seat cover.
Refer to Figure 4 for the following:
17. Route the tapes and buckles at the front of the seat
insert under the seat, above all mechanisms and wiring
assemblies. Route the rear tape through the three
elastic loops.
18. Fasten the buckles and tension by pulling the loose end
of the fastening strap. Tuck excess tape out of sight.
Refer to Figure 5 for the following:
19. Tuck the pocket in the seat cover into the seat back
pocket.
20. Some periodic adjustment and re-tensioning may be
required.
FIGURE 3