FD1227
18JUN04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
FITTING INSTRUCTIONS FOR
VZ SEDAN, (Except Calais) WAGON, UTE, & CAB CHASSIS
BONNET PROTECTOR
Part No. 92209791
FITTING INSTRUCTION
NOTE: It is recommended that the vehicle is washed
and dry before starting to fitting the bonnet protector.
1. Pull the bonnet latch to release the bonnet, lift the safety
latch under the front edge of the bonnet to allow the gas
struts to open the bonnet.
2. Place the bonnet protector (1) in position and note the
holes where the screw lugs (2) will go. Remove the
bonnet protector. Refer to Figure 1.
3. Fit the four screw lugs (1) in the holes with the raised
rectangle (2) on the lug parallel to the front edge of the
bonnet (3). Refer to Figure 2.
4. Fit the plastic clips (1) on each end of the bonnet
protector (2). Refer to Figure 3.
TOOLS REQUIRED:
Phillips Head Screwdriver
FIGURE 2
3
1
FIGURE 1
Page 1 of 2
1
2
2
FIGURE 3
2
1
FD1227
18JUN04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
FITTING INSTRUCTIONS FOR
VZ SEDAN, (Except Calais) WAGON, UTE, & CAB CHASSIS
BONNET PROTECTOR
Page 2 of 2
PARTS LIST
FITTING INSTRUCTIONS: Continued...
5. Fit the bonnet protector (1) ensuring the rectangle on
each of the lugs is located inside the slotted holes in the
bonnet protector. Place the washers (2) provided on
each of the four fixing screws (3) and fix the bonnet
protector to the vehicle. Refer to Figure 4.
6. Use the cleaning pad to clean the bonnet in the area
where the bonnet protector clips will clip over the edge of
the bonnet.
7. Peel off the backing paper from the abrasive resistant
patch and wrap around the edge of the bonnet (1) where
the plastic clip will fit (2). Repeat on other side. Refer to
Figure 5.
8. Fit both clips (1) onto the bonnet (2). Refer to Figure 6.
9. Place fitting instructions in the glovebox.
PART NUMBER DESCRIPTION QUANTITY
92209791 BONNET PROTECTOR KIT 1
BONNET PROTECTOR 1
92148573 SMALL PART KIT 1
WASHER 4
SCREW - SELF TAPPING 4
SCREW LUG 4
CLIPS 2
ABRASIVE RESISTANT PATCH 2
CLEANING PAD 1
FD1227 FITTING INSTRUCTIONS 1
FD796 PROOF OF WARRANTY CARD 1
1
2
2
1
FIGURE 6
1
3
2
FIGURE 5
FIGURE 4