FITTING INSTRUCTIONS

1. Remove head restraint assembly and 'elevate' seat to highest position.

2. Insert head restraint mounting assembly through 2 holes in front seat insert upper.

3. Fit head restraint and front seat insert to backrest Refer. View A

4. Feed fastening buckles through between seat and backrest. Fit seat section into position ensuring

to tuck 20 to 30mm in between seat and backrest. Refer. Section A-A.

5. Feed front fastening buckles under the seat, above and over all adjustments and wiring

assemblies. Refer View B

6. Fasten buckles and tension by pulling loose end of fastening strap. Tuck excess tape out of sight.

7. Some periodic adjustment and re-tensioning may be required to maintain the best fit.

WASHING INSTRUCTIONS

Dry cleaning recommended.

Hand wash with approved wool detergents. Do not soak for prolonged periods.

Rinse and gentle spin (fleece out) dry away from direct heat, preferably flat in shaded area.

While still damp, gently pull into shape and brush with a coarse stiff brush to restore pile.

FITTING INSTRUCTIONS FOR

VT / VX FRONT SEAT INSERTS

Part No. 92143312 (Shale)

Part No. 92143313 (Pewter)

FD979

07JL00

Page 1 of 2

FD979-01

HOLDEN SERVICE PARTS OPERATIONS

Reproduction in whole or part

prohibited without written approval

Division of HOLDEN Ltd ACN 006 893 232

FITTING INSTRUCTIONS FOR

VX FRONT SEAT INSERTS

FD979

07JL00

Page 2 of 2

FD979-02

HOLDEN SERVICE PARTS OPERATIONS

Reproduction in whole or part

prohibited without written approval

Division of HOLDEN Ltd ACN 006 893 232

VIEW A

VIEW B

ROUTE FASTENING CLIPS

UNDER THE SEAT, ABOVE

ALL MECHANISMS AND

WIRING ASSEMBLIES

A-A

SECTION

BACKREST

SEAT

CUSHION

SEAT

INSERT

TUCK 20-30mm OF SEAT

INSERT IN BETWEEN SEAT

CUSHION AND SEAT BACK

FRONT

FRONT SEAT

INSERT UPPER