FITTING INSTRUCTIONS FOR

VU UTILITY ROLL-UP SUNBLIND KIT

Part Number 92142518

Page 1 of 2

HOLDEN SERVICE PARTS OPERATIONS

Reproduction in whole or part

prohibited without written approval

Division of HOLDEN Ltd ACN 006 893 232

FD988

04NOV00

FD988-1

FITTING INSTRUCTIONS

1. Position the sunblind centrally

below the rear window, aligning it with the

lower edge of the rear trim fasteners, refer Page 2.

2. Using the sunblind as a template, mark the screw holes 2 places each side. Refer page 2.

3. Carefully drill the four holes using a 2mm drill bit.

4. Vacuum up any swarf as required.

5. Install the sunblind using the screws supplied and tighten to 1-3 Nm.

6. Raise the sunblind to the top of the window glass and mark the position of the loops on the glass

using a marker pen. Refer View A, page 2.

NOTE: Ensure enough clearance with the headlining for unhooking the loops.

7. Align the hooks with the loop marks and make a new mark just below each hook.

NOTE: The hooks can be tucked behind the headlining as required.

8. Using the Medi-Swab supplied, clean the glass in the area of the hooks.

NOTE: Do not remove the lower mark.

9. Peel off the backing paper and affix the hooks to the glass with even, firm pressure.

10. Remove the pen marks with the Medi-Swab.

IMPORTANT: Before using the sunblind allow 24 hours for the adhesive to reach maximum strength.

Page 2 of 2

FD988-2

HOLDEN SERVICE PARTS OPERATIONS

Reproduction in whole or part

prohibited without written approval

Division of HOLDEN Ltd ACN 006 893 232

PART NO. DESCRIPTION QUANTITY

SUNBLIND 1

HOOKS 2

MOUNTING SCREWS 4

MEDI-SWAB 2

FD988 ROLL-UP SUNBLIND FITTING INSTRUCTIONS 1

PARTS LIST

VIEW A

SUNBLIND

SCREW,

2 PLACES

SCREW,

2 PLACES

ALIGN SUNBLIND WITH

LOWER EDGE OF TRIM

FASTENERS

MARK LOOP POSITION

ALIGN HOOK ON

LOOP MARK

TUCK HOOK BEHIND

HEADLINING

MAKE NEW MARK

BELOW HOOK

CLEAN AREA PRIOR

TO AFFIXING HOOK

1-3 Nm

FD988

04NOV00