
Page 2 of 2
FD900
30NO98
G158-2
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
COPYRIGHT
1. Remove rear parcel shelf from vehicle.
2. Place rear window blind on parcel shelf, with equal
margin to edge of parcel shelf each side and 35mm
back from rear edge of pivot bracket, as shown in
figure 1.
3. Use blind as a template to mark mounting hole
locations, 4 places.
4. Remove blind and drill 4.0mm dia. holes, 4 places.
5. Attach blind to upper surface of parcel shelf using
screws, washers and nuts supplied in package.
NOTE: Blind assembly must be fitted so retractable
blinds are easily withdrawn towards front of vehicle.
Be sure slots in tube favour a frontal position, refer
Figure 2.
6. Cut off excess screw length from underside of parcel
shelf to minimize screw protrusion into rear
compartment.
7. Mark and drill a 3.0mm hole in each rear window
side trim, at location shown in Figure 2.
NOTE: Limit drilling depth to 10.0mm maximum when
drilling trim, to prevent contact with sheet metal.
8. Attach one hook to each rear window side trim using
self tapping screw.
9. Refit parcel shelf.
NUT
(2 PLACES
EACH SIDE)
WASHER
(2 PLACES
EACH SIDE)
SCREW
(2 PLACES
EACH SIDE)
REAR WINDOW BLIND
REAR PARCEL SHELF
DRILL
4.0 DIA.
HOLE
(2 PLACES
EACH SIDE)
FIGURE 1
FIGURE 2
35.0
PIVOT
BRACKET
75.0
17.0
SELF
TAPPING
SCREW
PLASTIC HOOK
LHS SHOWN
RHS OPPOSITE
DRILL 3.0 DIA HOLE
(LIMIT DRILLING
DEPTH TO 10.0) REAR WINDOW
SIDE TRIM
DESCRIPTION QUANTITY
BLIND, REAR WINDOW 1
SCREW 4
WASHER 4
NUT 4
HOOK, REAR BLIND 2
SCREW, SELF TAPPING 2
PARTS LIST
PLACE BLIND
ON PARCEL SHELF
TO ACHIEVE EQUAL
MARGIN EACH SIDE