FITTING INSTRUCTIONS
1. Remove head restraint assembly and 'elevate' seat to highest position. Refer Views A , B & C page 2.
2. Insert head restraint mounting assembly through 2 holes in front seat insert upper.
3. Refit head restraint and align front seat insert to backrest. Refer. View A, page 2.
4. Feed fastening buckles through between seat and backrest. Fit seat section into position ensuring to
tuck 20 to 30mm in between seat and backrest. Refer. Section A-A, page 2.
5. Feed front fastening buckles under the seat, above and over all adjustments and wiring assemblies.
Refer View B, page 2.
6. Fasten buckles and tension by pulling loose end of fastening strap. Tuck excess tape out of sight.
7. Some periodic adjustment and re-tensioning may be required to maintain the best fit.
WASHING INSTRUCTIONS
Dry cleaning recommended.
Hand wash with approved wool detergents. Do not soak for prolonged periods.
Rinse and gentle spin (fleece out) dry away from direct heat, preferably flat in shaded area.
While still damp, gently pull into shape and brush with a coarse stiff brush to restore pile.
FITTING INSTRUCTIONS FOR
V2 "MONARO" COUPE FRONT SEAT INSERTS
Part No. 92144463
FD1031
12SE01
COPYRIGHT
Page 1 of 2
FD1031-01
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of HOLDEN Ltd ACN 006 893 232
FD1031
12SE01
Page 2 of 2
FD1031-02
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN SERVICE PARTS OPERATIONS
Division of HOLDEN Ltd ACN 006 893 232
VIEW A
VIEW B
ROUTE FASTENING CLIPS
UNDER THE SEAT, ABOVE
ALL MECHANISMS AND
WIRING ASSEMBLIES
A-A
SECTION
BACKREST
SEAT
CUSHION
SEAT
INSERT
TUCK 20-30mm OF
SEAT INSERT IN
BETWEEN SEAT
CUSHION AND
SEAT BACK.
FRONT
B
A
A
A
C
D
C
D
PUSH BUTTON
TO RELEASE
PUSH PIN
TO RELEASE
FITTING INSTRUCTIONS FOR
V2 "MONARO" COUPE FRONT SEAT INSERTS