COPYRIGHT
Reproduction in whole or part
prohibited without written approval
FD1327
09DE04
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Part No. 92176667
Page 1 of 1
FITTING INSTRUCTIONS:
1. If fitted remove licence plate.
2. With locating tabs facing upwards and the fixings
facing the front of the vehicle, insert the insect
screen through the front fascia aperture.
3. Angle the screen to allow the screen and the top
locating tabs to straddle the fascia support beam
lower vertical flange. Refer Section A-A.
4. Align the screen centrally within the lower fascia
opening
5. Start the screws in the fixing and us the screws to pull
the screen forward to the inner edge of the lower
fascia opening, Locate the fascia into the lower
screen fixing. Secure with the bolt, washer and
locking wedge. Refer Section A-A.
6.
7.
Refit licence plate.
Place the fitting instructions in the vehicles
glovebox.
TOOLS REQUIRED:
Phillips Head Screwdriver.
LOCATING
TAB
INSECT
SCREEN
FASCIA
SUPPORT
BEAM
A-A
SECTION
A
VIEW
INSECT SCREEN
INSERT THROUGH FASCIA
A
LOCATING
TABS
A
A
WEDGE
WASHER
BOLT
FIXING
PART No DESCRIPTION QTY
92176667 INSECT SCREEN - FASCIA MOUTH 1
BOLT 2
WASHER 2
WEDGE 2
FD1327 FITTING INSTRUCTION BOOKLET 1
Parts List
FITTING INSTRUCTIONS FOR
VZ V6 AWD CREW CAB
INSECT SCREEN
FIXINGS
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
FD1327
09DE04
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
Part No. 92176668
FITTING INSTRUCTIONS:
1. If fitted remove licence plate.
2. With the fixing located nearest the ends of the insect
screen at the top facing forward, angle and insert the
insect screen through the front fascia apertures.
3. Align the screen centrally within the lower fascia opening
4. Start the two long screws in the lower fixings and us the
screws to pull the screen forward to the lower edge of the
fascia aperture. Locate the fascia into the lower screen
fixing. Secure with the bolt, washer and locking wedge.
Refer Section A-A.
5. Using the two short screws pull the top fixings forward to
the top fascia aperture edge. Locate the fascia into the
upper screen fixing and secure with the bolt, washer and
locking wedge. Refer Section A-A.
NOTE: A small hook may assist holding the screen in
position whilst tightening the screws. Refer to Figure 1.
7.
6. Refit licence plate.
Place the fitting instructions in the vehicle glovebox.
TOOLS REQUIRED:
Phillips Head Screwdriver.
A-A
SECTION
A
VIEW
INSECT SCREEN
INSERT THROUGH FASCIA
FIXINGS
A
WEDGE
WASHER
BOLT
FIXING
FITTING INSTRUCTIONS FOR
VZ V6 AWD WAGON
INSECT SCREEN
A
PART No DESCRIPTION QTY
92176668 INSECT SCREEN - FASCIA MOUTH 1
BOLT (25mm) 2
BOLT (50mm) 2
WASHER 4
WEDGE 4
FD1327 FITTING INSTRUCTION BOOKLET 1
Parts List Figure 1
Page 1 of 1