FD1234
01JUL04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
FITTING INSTRUCTIONS FOR
VZ CALAIS BONNET PROTECTOR
Page 1 of 2
TOOLS REQUIRED:
Phillips Head Screwdriver.
FITTING INSTRUCTION
NOTE: It is recommended that the vehicle is washed
and dry before starting to fit the bonnet protector.
1. Pull the bonnet latch to release the bonnet (1), lift the
safety latch under the front edge of the bonnet to allow
the gas struts to open the bonnet.
2. Place the bonnet protector (1) in position and note the
holes where the screw lugs will go. Remove the bonnet
protector. Refer to Figure 1.
3. Fit the large screw lugs (1) in the middle bonnet holes (2
places) and the small screw lugs in the outer bonnet
holes (in 2 places). Refer to Figure 2.
4. Fit the plastic clips (1) on each end of the bonnet
protector (2). Refer to Figure 3.
Part No. 92174570
2
1
1
2
FIGURE 1
FIGURE 2
FIGURE 3
1
FD1234
01JUL04
COPYRIGHT
Reproduction in whole or part
prohibited without written approval
HOLDEN LTD
Division of HOLDEN Ltd ACN 006 893 232
FITTING INSTRUCTIONS FOR
VZ CALAIS BONNET PROTECTOR
Page 2 of 2
PARTS LIST
PART NUMBER DESCRIPTION QUANTITY
92174570 BONNET PROTECTOR KIT 1
BONNET PROTECTOR 1
92148572 SMALL PART KIT 1
WASHER 4
SCREW - SELF TAPPING 15mm 2
SCREW - SELF TAPPING 10mm 2
SCREW LUG LARGE 2
SCREW LUG SMALL 2
CLIPS 2
ABRASIVE RESISTANT PATCH 2
CLEANING PAD 1
FD1234 FITTING INSTRUCTIONS 1
FD796 PROOF OF WARRANTY CARD 1
FITTING INSTRUCTION: Continued...
5. Put the washers (1) on the screws (2), then fit the
bonnet protector (3). Use the two large screws in the
two centre screw lugs (4), and the two smaller screws in
the two outer screw lugs (4) and tighten.
Refer to Figure 4.
Refer to Figure 5 for the following:
6. Use the cleaning pad to clean the bonnet in the area
where the bonnet protector clips will clip over the edge
of the bonnet.
7. Peel off the backing paper from the abrasive resistant
patch and wrap around the edge of the bonnet (1) where
the plastic clip will fit (2). Repeat on other side.
8. Fit the clips (1) onto the bonnet (2). Refer to Figure 6.
3
2
1
FIGURE 4
4
1
2
2
1
FIGURE 5
FIGURE 6