FITTING INSTRUCTIONS:
NOTE: It is recommended to use a 2-post hoist, to ease
mud flap installation.
1. Place vehicle in position on hoist. Refer to the Owners
Manual for correct jacking positions.
Refer Figure 2.
NOTE: Take care to drill through the wheel arch liner
only. Do not come into contact with the metal surface
behind the liner.
2. Remove the front wheels.
3. Firmly holding the mud flap in place, mark the position
of the holes (2 places) on the inside of the wheel arch.
Refer Figure 1.
4. Drill holes through the wheel arch liner with the 8.0mm
bit and electric drill.
FITTING INSTRUCTIONS FOR
ZC VECTRA
FRONT MUD FLAPS
Part No. 92145496
MOULDED
COPYRIGHT
FD1120
13DE02
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of General Motors - Holden's Automotive Limited ACN 006 893 232
Page 1 of 2
G758
TOOLS REQUIRED:
Electric Drill (Battery Powered) T20 Torx bit., 8.0mm Drill Bit, Marker, Torque Wrench and
FIGURE 1
FIGURE 2
8.0MM
DRILL BIT
ELECTRIC
DRILL
MARK THE POSITION
OF THE HOLES
PRIOR TO DRILLING
MUD FLAP
HOLD MUD
FLAP FIRMLY
IN POSITION
ZC VECTRA MUD FLAPS
PARTS LIST
PART NUMBER DESCRIPTION QUANTITY
92145496 FRONT MUD FLAP KIT 1
LH MUD FLAP 1
RH MUD FLAP 1
SCREW CLIPS 2
SELF TAPPING SCREWS 2
PLASTIC RIVETS 4
FD1120 FITTING INSTRUCTIONS 1
FITTING INSTRUCTIONS:
5. Slide the green screw clip over the hole in the rocker
panel skirt. Refer Figure 3
6. Fix the mud flap by pushing the plastic rivets in place
and pushing the centre button in. Fix the torx screw into
the hole in the base of the mud flap screwing it into the
green screw clip. Refer Figure 4.
NOTE: Hold the mud flap firmly against vehicle while
tightening fasteners to ensure a flush fit.
7. Tighten all screws to specified torque.
8. Repeat for opposite side of the vehicle.
9. Place fitting instructions in glove box.
FITTING INSTRUCTIONS FOR
ZC VECTRA
FRONT MUD FLAPS
Part No. 92145496
MOULDED
COPYRIGHT
FD1120
13DE02
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of General Motors - Holden's Automotive Limited ACN 006 893 232
Page 2 of 2
11.0~3.0 Nm
FIGURE 3
FIGURE 4
EXISTING
HOLE IN
ROCKER PANEL
SKIRT SCREW CLIP
PUSH IN THE
CENTRE OF THE
PLASTIC RIVET
PLASTIC
RIVET
SELF TAPPING
SCREW 1
G758
A
A
ROCKER
PANEL
SKIRT
SCREW
CLIP
A-A
ROCKER
PANEL
SKIRT
SCREW
CLIP
SCREW
A
A-A
A