1
MUD FLAP
FITTING INSTRUCTIONS:
NOTE: It is recommended to use a 2-post hoist, to ease
mud flap installation.
1. Place vehicle in position on hoist. Refer to the Owners
Manual for correct jacking positions.
2. Remove the rear wheels.
3. Locate and remove the existing screws (2 places) from
the rear wheel arch liner and retain. Refer Figure 1.
4. Assemble the mud flaps, spacers (2 places) and
existing screws (2 places) as shown and install.
NOTE: Do not tighten at this point.
FITTING INSTRUCTIONS FOR
ZC VECTRA
MUD FLAPS
Part No. 92145497
MOULDED REAR
COPYRIGHT
FD1121
13DE02
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of General Motors - Holden's Automotive Limited ACN 006 893 232
Page 1 of 2
G759
TOOLS REQUIRED:
Electric Drill (Battery Powered) T20 Torx bit., 8.0mm Drill Bit, Marker, Torque Wrench and
FIGURE 1
FIGURE 2
EXISTING
SCREWS
EXISTING
SCREW
SPACERS
11.0~3.0 Nm
ZC VECTRA MUD FLAPS
PARTS LIST
PART NUMBER DESCRIPTION QUANTITY
92145497 REAR MUD FLAP KIT 1
LH MUD FLAP 1
RH MUD FLAP 1
SPACERS 4
PLASTIC RIVETS 2
FD1121 FITTING INSTRUCTIONS 1
FITTING INSTRUCTIONS:
NOTE: Take care to drill through the wheel arch liner
only. Do not come into contact with the metal surface
behind the liner.
NOTE: Hold the mud flap firmly against vehicle while
tightening fasteners to ensure a flush fit.
5. Using the existing hole in the mud flap as a template,
drill an 8.0mm diameter hole in the rocker panel skirt
from below. Refer Figure 3.
6. Instal the plastic rivet and lock by pushing the centre
button in until it is flush. Refer Figure 4.
7. Tighten all screws to specified torque.
8. Repeat for opposite side of the vehicle.
9. Place fitting instructions in glove box.
COPYRIGHT
FD1121
13DE02
HOLDEN SERVICE PARTS OPERATIONS
Reproduction in whole or part
prohibited without written approval
Division of General Motors - Holden's Automotive Limited ACN 006 893 232
Page 2 of 2
FIGURE 3
FIGURE 4
G759
PLASTIC
RIVET
MUD
FLAP
ELECTRIC
DRILL
8.0MM
DRILL
BIT MUD
FLAP
EXISTING
HOLE IN
MUD FLAP
FITTING INSTRUCTIONS FOR
ZC VECTRA
MUD FLAPS
Part No. 92145497
MOULDED REAR