SECTION 7A - WH SERIES ALLOY WHEEL & TYRE
PACKAGES
1. GENERAL INFORM ATION
This Section of the Holden By Design Service
Information Supplement describes the two 17 x 8
alloy wheel and tyre packages available for WH
Series vehicles.
The packages consist of four alloy rims fitted with
235/45 R17 93V tubeless tyres. A steel rim spare
wheel is supplied for temporary use.
NOTE. W hen the spare wheel is fitted, vehicle speed
is limited to 80 km/h. Refer to owners manual for
further information.
The C-series five spoke alloy wheel (1) is based on
the Holden Special Vehicles Clubsport rim and was
introduced as a Holden By Design option for WH
Series vehicles in October 1999. Included are wheel
nuts (2), nut covers (3) and wheel cap (4).
Figure 7A-1
The the sports alloy rim (1) is also currently fitted to
export WH Series Caprice SS models and was
introduced as a Holden By Design option for WH
Series vehicles early 2000. Included are wheel nuts
(2), nut covers (3) and wheel cap (4).
Figure 7A-2
W hen either of the Holden By Design alloy wheel and
tyre pack ages are f itted, the standard tyre placard (1) ;
located on the end surface of the right-hand front
door (2), is replaced with a new placard that reflects
the new tyre package, refer Fig. 7A-4.
Figure 7A-3
Figure 7A-4
2. SPECIFICATIONS
ALLOY WHEELS
Rim Width Code.............................................................................. 8.0J
Diameter Code................................................................................ 17
Maximum Permissible Radial Run-out............................................ 0.25 mm
Maximum Permissible Lateral Run-out........................................... 0.3 mm
Offset .............................................................................................. 48 mm (pos)
TYRES
Dynamic Balancing
Maximum Permissible Wheel/Tyre Out of Balance................. 120 g
Maximum Permissible Weight for any One Flange................. 80 g
Maximum Permissible Tyre Radial 1st Harmonic
Force Variation (tyre only)....................................................... 65 N
Maximum Load Rating (per tyre) .................................................... Refer to Tyre Placard on Vehicle
3. TORQUE WRENCH SPECIFICATIONS
Road Wheel Attaching Nuts............................................................ 110 – 140 Nm