SECTION 6H - ACCELERATOR CONTROL
Removal and Installation
Removal
Inspection
Installation
REMOVAL AND INSTALLATION
RTW46HLF000201
RTW46HMH000201
Removal
1. Disconnect the accelerator control cable from the
accelerator pedal and dash panel.
2. Remove the cable clips.
3. Remove the accelerator control cable from accelerator
control cable bracket.
1) Slide the lock in direction A.
2) Rotate the ratchet ring 90° in opposite direction of
arrow.
4. Remove the accelerator control cable from the
throttle.
Inspection
Check the following items and replace the control cable if
any abnormality is found.
• The control cable should move smoothly.
• The control cable should not be bent or kinked.
• The control cable should not be damaged or
corroded.
Installation
1. Install the accelerator control cable to accelerator
control pedal dash panel.
2. Install the accelerator control cable to throttle.
Attach T-END and inner cable to throttle cam of
engine.
3. Install accelerator control cable to accelerator bracket.
1) Rotate the ratchet ring in direction of arrow 90°
until both white marks are aligned.
2) Confirm marking on outer cap is facing upper side.
3) Slide the lock in direction B.
4) Confirm ratchet ring is locked.
4. Install the cable clips to accelerator control cable.
NOTE:
Confirm that the throttle (engine side) is at full stroke
when the accelerator pedal is fully depressed.