holden.wiki

• Model Selection Index
• RA Rodeo
• Section 7C4Automatic Transmission – 4L60E – On-vehicle Ser
  • 1 General Information
    • 1.1 General Service Information
      • Description
      • Service Information
    • 1.2 WARNINGS, CAUTIONS and NOTES
      • Definition of WARNING, CAUTION and NOTE Statements
        • WARNING Defined
        • CAUTION Defined
        • NOTE Defined
  • 2 Maintenance Operations
    • 2.1 Transmission Fluid
      • Transmission Fluid Colour
      • Transmission Fluid Level
    • 2.2 Reverse Flush and Flow Rate Test
      • Reverse Flush
      • Flow Rate Test
  • 3 Service Operations
    • 3.1 Fluid Change and Filter Replacement
      • Remove
      • Reinstall
    • 3.2 Shift Selector Assembly
      • Remove
      • Reinstall
    • 3.3 Selector Cable Assembly
      • Remove
      • Reinstall
    • 3.4 Neutral Start and Back-up Lamp Switch
      • Remove
      • Reinstall
      • Adjust
    • 3.5 Vehicle Speed Sensor
      • Remove
      • Reinstall
    • 3.6 Manual Shaft Oil Seal
      • Replace
    • 3.7 Transmission Support and Mount
      • Remove
      • Reinstall
    • 3.8 Extension Housing Oil Seal, RWD
      • Replace
    • 3.9 Extension Housing and Rear Bush, RWD
      • Remove
      • Reinstall
    • 3.10 Adaptor Housing, 4WD
      • Remove and Reinstall
    • 3.11 Shift Solenoid Locations
      • Location and Identification
    • 3.12 1 – 2 Accumulator Assembly
      • Remove
      • Clean and Inspect
      • Reinstall
    • 3.13 Control Valve Body Harness
      • Remove
      • Reinstall
    • 3.14 Control Valve Body
      • Remove
      • Reinstall
    • 3.15 Spacer Plate, Check Balls, Filter Screens and 3 – 4 Acc
      • Remove
      • Clean and Inspect
      • Reinstall
    • 3.16 Filler Tube and Breather Hose
      • Remove
      • Reinstall
    • 3.17 Transmission Cooler Line/Hose Assemblies
      • Remove
      • Reinstall
    • 3.18 Transmission Assembly
      • Remove
      • Reinstall
    • 3.19 Transmission Control Module
      • Remove
      • Reinstall
      • TCM Programming Procedure
  • 4 Specifications
  • 5 Torque Wrench Specifications
  • 6 Special Tools