SECTION 1A2 - BODY DIMENSIONS
IMPORTANT:
Before performing any Service Operation or other procedure described in this Section, refer to Section
00 CAUTIONS AND NOTES for correct workshop practices with regard to safety and/or property damage.
1. GENERAL DESCRI PTI O N
VU Series Models ar e based on VX Ser ies s tation wagon m odels and f eatur e the s ame track and wheelbase. Major
exterior changes are new outer side panels, roof, rear glass, load compartment floor and endgate.
2. SERVICE OPERATIONS
For Service Operations not covered in this Section refer to Section 1A2 BODY DIMENSIONS in the VT Series
Service Information.
2.1 BODY DIMENS IONS
Correct underbody alignment is essential, as any misalignment of the underbody can adversely affect suspension,
fitment of doors, engine hood and endgate. The underbody should therefore be aligned to within ±1.5 mm of
dimensions specified in Figs. 1A2-1, 1A2-2, 1A2-3, 1A2-4 and 1A2-5. These dimensions should be accurately
checked with a trammel gauge consisting of a parallel bar or rod, fitted with two adjustable trammels, capable of
gauging all underbody dimensions specified.
In preparing for an underbody alignment check, place the vehicle on a level surface with the weight of the body
supported at wheel locations.
Dimensions to holes are to be taken from the centreline.
Body dimensions are to be taken to the outside surface of the sheetmetal.
All dimensions are to be measured as shown.
AB C D E
19
91919
1096
1620
508
151 15 75 137RH127
LH
1180
450
450
460
460
460506 RHS
535 LHS
460
507
387
752
439
521
1858 1490
1777
F
1745
1474
1454
VU1A2001a
Figure 1A2-1
Legend
Datum surface under side of longitudinal R & LH.
Cockpit module attachment All dimensions in mm. measured from centre of
holes on outside of panel
Figure 1A2-2
Figure 1A2-3
Figure 1A2-4
Figure 1A2-5