SECTION 1A3 - INSTRUMENT AND CONSOLE

IMPORTANT:

Before performing any Service Operation or other procedure described in this Section, refer to

Section 00 CAUTIONS AND NOTES for correct workshop practices with regard to safety and/or property

damage.

1. GENERAL I NFORMATI O N

All information relating to the instrument panel and console fitted to VX Series Models is as detailed in

Section 1A3 INSTRUMENT PANEL AND CONSOLE in the VT Series Service Information, noting the following:

• A new cupholder has been fitted to Berlina and Calais.

Techline

2. SERVICE OPERATIONS

2.1 CUP HOLDER (BE RLINA AND CALAIS)

REMOVE

1. Open the cupholder lid (2).

2. Grasp the rear of the cupholder assembly (1)

and press forward to disengage the rear

retaining tang (3) from the centre console.

3. Withdraw the cup holder from the centre

console, taking care not to damage the front

locating tab (4).

Figure 1A3-1

LATCH REPLACE

1. With the cup holder removed from the centre

console and the lid (2) open, grasp with both

hands and press the latch (1) firmly up out of

cup holder with thumb.

2. Carefully press replacement latch into place by

hand, ensuring the latch locking tabs are

correctlty engaged.

CAUTION: Do not press directly on the latch jaws.

REINSTALL

1. Engage the cup holder front locating tab in the

slot in the centre console and press the rear

edge firmly into place until rear locking tab is

correctly engaged.

NOTE: If the rear locking tab on the cup holder

does not correctly engage, open the cup holder lid

to gain access.

Figure 1A3-2

Techline