HVAC Climat e Control (Manual A/C) – Removal and Inst al l ation Page 2B–1

Page 2B–1

Section 2B

HVAC Climate Control (Manual A/C) – Removal

and Installation

ATTENTION

Before performing any Service Operation or other procedure described in this Section, refer to Section 00

Warnings, Cautions and Notes for correct workshop practices with regard to safety and/or property damage.

1 General Information............................................................................................................................... 2

2 Service Procedures ............................................................................................................................... 3

2.1 Body Ventilation Outlets........................................................................................................................................3

Remove ...................................................................................................................................................................3

Reinstall ..................................................................................................................................................................4

Techline

HVAC Climat e Control (Manual A/C) – Removal and Inst al l ation Page 2B–2

Page 2B–2

1 General Information

The basic HVAC system as fitted to MY 2003 VY Regular Cab vehicles is carried over from previously released MY 2003

VY Series utility vehicles. The removal and installation procedure of the body ventilation outlets is unique to the MY 2003

VY Regular Cab vehicles and is covered in this Section.

For all other information regarding the removal and installation of heating, ventilation and air conditioning system

components, refer to Section 2B HVAC Climate Control (Manual A/C) – Removal and Installation in the MY 2003 VY and

V2 Series Service Information.

HVAC Climat e Control (Manual A/C) – Removal and Inst al l ation Page 2B–3

Page 2B–3

2 Service Procedures

2.1 Body Ventilation Outlets

Figure 2B – 1

Legend

1 Outlet Housing 4 Locking Tab (4 places)

2 Rubber Seal 5 Body Panel

3 Foam Seal

NOTE

For body ventilation outlet locations, refer to

Figure 2B – 2.

LT Section – 08-700

Remove

1 Remove the seat back body panel trim assembly. Refer to Section 1A8, 2.2 Seat Back Body Panel Trim.

2 Remove the rear outer trim panel. Refer to Section 1A9, 2.7 Rear Outer Trim Panel and NVH Foam.

3 From inside the passenger compartment, press the locking tabs at each corner of the ventilation outlet housing

while simultaneously moving it partially outward of the passenger compartment.

4 Remove the body ventilation outlet from the rear inner panel.

HVAC Climat e Control (Manual A/C) – Removal and Inst al l ation Page 2B–4

Page 2B–4

Reinstall

Installation of the body ventilation outlet is the reverse of removal procedures, noting the following points:

1 Install the body ventilation outlet in the correct vertical orientation, i.e. as shown in Figure 2B – 1

2 Ensure all four locking tabs are fully engaged on the inner side of the rear inner panel.

Figure 2B – 2 shows the locations of body ventilation outlets on MY 2003 VY Regular Cab vehicles.

Figure 2B – 2

Legend

1 Body Ventilat ion Outlet – LHS 2 Body Ventilat ion Outlets – RHS