SECTION 1C - RADIATOR GRILLE
IMPORTANT
Before performing any Service Operation or other procedure described in this Section, refer to
Section 00 CAUTIONS AND NOTE for correct workshop practices with regard to safety and/or
property damage.
1. GENERAL DESCRI PTI O N
The WH Series Model grille assembly is secured to a support, which is integral with the engine hood
assembly.
2. SERVICE OPERATIONS
2.1 RADIATOR GRILLE
REMOVE
1. Raise the engine hood.
2. Remove the nuts securing the grille insert to
the engine hood assembly, refer Fig. 1C-1.
REINSTALL
Reinstallation of radiator grille is the reverse of the
removal operation, noting the following:
1. Ensure the grille assembly is correctly located
in the engine hood assembly.
2. Tighten grille retaining nuts to the correct
torque specification.
GRILLE RETAINING NUTS 0.1 - 0.3
TORQUE SPECIFI CATION Nm
Figure 1C-1
>Locate central locating pin in hole on engine hood.
Ensure grille edge seal is secured between grill edge
and engine hood.
1. Nut (7 places).
2. Screw.
3. Grille edge Seal.
4. Reinforcement Grille Support.
5. Statesman Grille.
6. Caprice Grille.