holden.wiki

• MODEL SELECTION INDEX
• MY 2005 WL Series - Service Information
• Section 8B Exhaust System
  • 1 General Information
    • 1.1 Emission Reductions
    • 1.2 Catalytic Converter
      • Service Notes
      • ADR 79/00 (Euro II) Emissions Standards
    • 1.3 Exhaust System Configurations
      • Alloytec 190 Engine
      • GEN III V8 Engine
  • 2 Service Operations – Alloytec 190
    • 2.1 Service Notes
      • Catalytic Converter
      • Oxygen Sensors
    • 2.2 Exhaust System
    • 2.3 Complete Exhaust System Assembly
      • Remove
      • Reinstall
    • 2.4 Rear Exhaust Assembly
      • Remove
      • Reinstall
    • 2.5 Intermediate Exhaust Assembly
      • Remove
      • Reinstall
    • 2.6 Front Exhaust Assembly
      • Remove
      • Reinstall
    • 2.7 Tightening Sequence
  • 3 Service Operations – GEN III V8
    • 3.1 Service Notes
      • Catalytic Converter
      • Oxygen Sensors
    • 3.2 Exhaust System
    • 3.3 Complete Exhaust System Assembly
      • Remove
      • Reinstall
    • 3.4 Rear Exhaust Assembly
      • Remove
      • Reinstall
    • 3.5 Intermediate Exhaust Assembly
      • Remove
      • Reinstall
    • 3.6 Front Exhaust Assembly
      • Remove
      • Reinstall
    • 3.7 Tightening Sequence
  • 4 Service Operations – Heat Shields
    • 4.1 Rear Heat Shield
      • Remove
      • Reinstall
    • 4.2 Intermediate Heat Shield
      • Remove
      • Reinstall
    • 4.3 Front Heat Shield – Underbody Mounted
      • Remove
      • Reinstall
    • 4.4 Front On-Pipe Heat Shield – Pre-catalytic Converter
      • Remove
      • Reinstall
    • 4.5 Front On-Pipe Heat Shield – Post-catalytic Converter
      • Remove
      • Reinstall
  • 5 Exhaust System Diagnosis
  • 6 Specifications
  • 7 Torque Wrench Specifications
  • 8 Special Tools