holden.wiki

• MODEL SELECTION INDEX
• RA RODEO
• SECTION 6A - ENGINE MECHANICAL
  • GENERAL DESCRIPTION
    • ENGINE PICTORIAL
  • Main Data and Specifications
    • CRANKCASE VENTILATION SYSTEM
    • ENGINE ASSEMBLY &LOOSE PARTS
  • OPERATIONS ON ENGINE AGGREGATES
    • Engine Damping Blocks (Engine Without Transmission)
    • Toothed Belt and Timing Check
    • Toothed Belt Tension,Adjust (Engines with toothed belt tension roller)
    • Toothed Belt,Replace (Engine with toothed belt tension roller)
  • OPERATIONS ON INSTALLED ENGINE
    • Gasket,Exhaust Manifold,Cylinder Head
    • Gasket,Intake Manifold,Cylinder Head
    • Seal Ring,Camshaft Housing,Timing Side
    • Seal Ring,Thermostat Housing,Cylinder Head
    • Seal Ring -Front Camshaft Housing,Replace
    • Toothed Belt Rear Cover (Engine with toothed belt tension roller)
    • Toothed Belt Tension Roller
  • COMPONENT PARTS
    • CYLINDER HEAD
    • HYDRAULIC VALVE LIFTER
  • OPERATIONS ON CYLINDER HEAD AND CAMSHAFT HOUSING
    • Camshaft
    • Camshaft Housing,Removal and Installation
    • Cylinder Head
    • Hydraulic Valve Lifters,Replace
    • Camshaft Housing,Replace
    • Camshaft Housing,Check for Plane Surface
    • Cylinder Head,Removal and Installation
    • Cylinder Head,Disassemble and Assemble
    • Valve,Grind
    • Valve Seating,Mill
    • Cylinder Head,Overhaul
    • Flywheel
    • Starter Ring Gear (Manual Transmission)
    • Seal Ring,Crankshaft (Oil Pump Housing)
    • Seal Ring,Crankshaft Rear
    • Gasket,Oil Pan
  • OPERATIONS ON CRANK CASE
    • Con-Rod Bearing
    • Piston with Con-Rod
    • Con-Rod
    • Piston Rings
  • OPERATIONS ON REMOVED ENGINE
    • Crankshaft
    • Bearing Free Play Measurement
    • Plastigage Method
    • Micrometer and gauge method.
    • Bypass Valve
    • Oil Filter
    • Oil Pump
    • Oil Pump Safety Valve
    • Oil Pump (Overhaul)
  • OPERATIONS ON OIL CIRCULATION
    • Cylinder Head Safety Valve
  • OPERATIONS ON COOLING SYSTEM
    • Cooling System,Check for Leaks
    • Cooling System,Fill Up and Bleed
    • Refill Coolant
    • Ignition Timing,Check
  • ENGINE EXTERNAL PARTS
    • Radiator
    • Thermostat
    • Water Pump
    • Coating sealing surfaces with Silicone Grease
    • Alternator
    • Starter
    • V-belt Tension of Alternator
  • FUEL INJECTION SYSTEM
    • MAP SENSOR
    • Pressure Regulator
    • ECM (Engine Control Module)
    • ECT
    • Idle Air Control (IAC)Valve
    • Ignition Coil
    • Crank Position Sensor
  • FUEL INJECTOR
    • Knock sensor
    • Oxygen Sensor (If applicable)
    • Throttle Valve Position Sensor
    • Accelerator Pedal and Cable
    • Air Cleaner Filter
    • Spark Plug Thread
  • TECHNICAL DATA
    • Recommended Torque Values
  • SPECIAL SERVICE TOOLS