holden.wiki

• Model Selection Index
• RA Rodeo
• Section 11A-1Immobiliser System – HFV6
  • 1 General Information
    • 1.1 Warning Caution and Notes
      • Definition of WARNING, CAUTION and NOTE Statements
        • WARNING defined
        • CAUTION defined
        • NOTE defined
  • 2 Component Location
    • 2.1 Engine Compartment
    • 2.2 Interior
  • 3 Component Description
    • 3.1 Immobiliser Control Unit
    • 3.2 Powertrain Interface Module
    • 3.3 Engine Control Module
  • 4 Diagnostics
    • 4.1 Diagnostic General Descriptions
      • Diagnostic Trouble Code (DTC) Tables
        • Multiple DTCs
      • Diagnostic Trouble Codes (DTCs)
        • Status of DTCs
        • Conditions for Clearing DTCs
      • Tech 2 ICU Diagnostic Tests
        • Tech 2 Limitations
        • Tech 2 Intermittent Fault Tests
  • 5 Wiring Diagram and Harness Connector
    • 5.1 Wiring Diagram
    • 5.2 Harness Connector
      • Immobiliser Control Unit Connector – B70
        • Pin Description
      • Immobiliser Control Unit Connector – B78
        • Pin Description
  • 6 Diagnostics Starting Point
    • 6.1 Diagnostic Requirements, Precautions and Preliminary Che
      • Basic Knowledge Required
      • Basic Diagnostic Tools Required
      • Diagnostic Precautions
      • Preliminary Checks
      • Diagnostic Aids
        • Check the condition for system parts.
        • Check the Electro Magnetic Interference (EMI)
        • Check the other items.
        • Check the operation
    • 6.2 Diagnostic Trouble Codes
      • Immobiliser Control Unit (ICU)
    • 6.3 Immobiliser System and Warning Lamp Check
      • Immobiliser System Check
      • No Immobiliser Warning Lamp
      • Immobiliser Warning Lamp On Steady
  • 7 Intermittent Fault Conditions
    • 7.1 Intermittent Conditions Diagnostic Table
      • Description
      • Diagnostic Table
  • 8 DTC Tables
    • 8.1 B0001 Replace Electronic Control Unit (Immobiliser Fault
    • 8.2 B0002 Immobiliser Not Programmed
    • 8.3 B0003 Transponder Key Problem
    • 8.4 B0004 Immobiliser Coil Circuit (Antenna Coil Fault)
    • 8.5 B0005 Communication Line W Voltage Low
    • 8.6 B0006 Communication Line W Voltage High
    • 8.7 B0007 No Engine Request Received
    • 8.8 B0008 Wrong Transponder Key
    • 8.9 B0009 No Transponder Key Programmed
    • 8.10 B0010 Unknown Transponder Key
    • 8.11 B0055 EEPROM Error
  • 9 Immobiliser Security and Programming
    • 9.1 Security and Programming Information
      • Car Pass Card
      • lmportant information on Programming
        • Security code
        • Entering a code
        • Transponder (Key)
    • 9.2 Immobiliser Control Unit Reset Procedure
    • 9.3 Immobiliser Link to ECM / PIM
  • 10 Immobiliser V6 – Tech 2 Functions
    • 10.1 Introduction
    • 10.2 Tech 2 Functions
      • F0: Diagnostic Trouble Codes
      • F1: Data Display
      • F2: Snapshot Options
      • F3: Additional Functions
      • F4: Programming
    • 10.3 Immobiliser V6 Data List
      • Data Display
  • 11 Special Tools