holden.wiki

• MODEL SELECTION INDEX
• VT SERIES I - COMMODORE, CALAIS SERVICE INFORMATION
• SECTION 3 - FRONT SUSPENSION
  • 1. GENERAL DESCRIPTION
  • 2. WHEEL ALIGNMENT
    • 2.1 STEERING GEOMETRY
      • CASTER
      • CAMBER
      • WHEEL TOE
      • STEERING AXIS INCLINATION
      • SCRUB RADIUS
      • INCLUDED ANGLE
      • TOE-OUT ON TURNS
    • 2.2 WHEEL ALIGNMENT CHECKING AND ADJUSTMENT
      • PRELIMINARY INSPECTION
      • CASTER ADJUSTMENT
      • CAMBER ADJUSTMENT
      • TOE ADJUSTMENT
    • 2.3 JACKING PRECAUTIONS
    • 2.4 FRONT WHEEL BEARING HUB - END FLOAT CHECKING PROCEDURE
  • 3. MINOR SERVICE OPERATIONS
    • 3.1 SUSPENSION AND TRIM HEIGHT, CHECK
    • 3.2 FRONT WHEEL HUB, BRAKE DISC OR BRAKE SHIELD
      • REMOVE
      • INSPECT
      • REINSTALL
    • 3.3 FRONT WHEEL HUB STUDS
      • REPLACE
  • 4. MAJOR SERVICE OPERATIONS
    • 4.1 FRONT STRUT ASSEMBLY
      • REMOVE
      • REINSTALL
    • 4.2 UPPER STRUT SUPPORT BEARING AND MOUNT
      • REMOVE
      • REINSTALL
    • 4.3 FRONT SPRING
      • REMOVE
      • REINSTALL
    • 4.4 FRONT STRUT UNIT
      • REPLACE
    • 4.5 STEERING KNUCKLE
      • REMOVE
      • REINSTALL
    • 4.6 LOWER CONTROL ARM
      • REMOVE
      • REINSTALL
    • 4.7 LOWER CONTROL ARM BALL JOINT
      • INSPECT
    • 4.8 LOWER CONTROL ARM INNER PIVOT BUSH
      • REPLACE
    • 4.9 LOWER CONTROL ARM TENSION ROD BUSH
      • REPLACE
    • 4.10 LOWER CONTROL ARM TENSION ROD
      • REMOVE
      • REINSTALL
    • 4.11 FRONT SUSPENSION TENSION ROD, HYDRAULIC DAMPER
      • REPLACE
    • 4.12 FRONT SUSPENSION CROSSMEMBER
      • REMOVE
      • REINSTALL
    • 4.13 STABILISER BAR
      • REMOVE
      • REINSTALL
  • 5. DIAGNOSIS
    • GENERAL
    • STRUT DIAGNOSIS
    • ACCEPTANCE CRITERIA
    • 5.1 DIAGNOSIS GUIDE
  • 6. SPECIFICATIONS
  • 7. TORQUE WRENCH SPECIFICATIONS
  • 8. SPECIAL TOOLS