holden.wiki

• MODEL SELECTION INDEX
• VT SERIES II - COMMODORE, CALAIS SERVICE INFORMATION
• SECTION 7B3 - MANUAL TRANSMISSION -GEN III V8 ENGINE
  • 1. GENERAL INFORMATION
    • 1.1 GENERAL DESCRIPTION
      • SYNCHRONISER ASSEMBLIES
      • REVERSE GEAR
      • BEARING SUPPORT
      • LUBRICATION
      • SELECTOR MECHANISM
      • REVERSE LOCKOUT MECHANISM
      • SHIFT PATTERN
      • POWER FLOWS
    • 1.2 TRANSMISSION SERIAL NUMBER
  • 2. SERVICING INFORMATION
    • 2.1 RECOMMENDED LUBRICANT
    • 2.2 CHECKING TRANSMISSION LUBRICANT LEVEL
    • 2.3 DRAINING AND REFILLING TRANSMISSION
  • 3. MINOR SERVICE OPERATIONS
    • 3.1 BACK-UP LAMP SWITCH
      • REPLACE
    • 3.2 SPEED SENSOR
      • REPLACE
    • 3.3 TRANSMISSION SUPPORT MOUNT
      • REPLACE
    • 3.4 REVERSE LOCKOUT SOLENOID ASSEMBLY
      • REMOVE
      • DISASSEMBLE
      • REASSEMBLE
      • REINSTALL
    • 3.5 CONTROL LEVER KNOB AND BOOT ASSEMBLY
      • REMOVE
      • REINSTALL
    • 3.6 GEARSHIFT CONTROL LEVER AND REMOTE SHIFTER SHAFT BOOT
      • REMOVE
      • CLEAN AND INSPECT
      • REINSTALL
  • 4. MAJOR SERVICE OPERATIONS
    • 4.1 TRANSMISSION OUTPUT SHAFT SEAL AND BOOT
      • REMOVE
      • REINSTALL
    • 4.2 TRANSMISSION ASSEMBLY
      • REMOVE
      • REINSTALL
    • 4.3 TRANSMISSION DISASSEMBLE
      • CLUTCH HOUSING AND SLAVE CYLINDER
      • EXTENSION HOUSING
      • SPEEDOMETER PULSE RING
      • REVERSE AND 5TH/6TH DRIVEN GEAR
      • COUNTERSHAFT EXTENSION ASSEMBLY
      • TRANSMISSION CASE
      • GEAR TRAINS AND SHIFT RAILS
    • 4.4 REMOTE CONTROL SHIFT MECHANISM
      • DISASSEMBLE
      • CLEAN AND INSPECT
      • REASSEMBLE
    • 4.5 TRANSMISSION SUB-ASSEMBLIES
      • DISASSEMBLE
      • CLEAN AND INSPECT COMPONENTS
      • REASSEMBLE
    • 4.6 BEARING SHIMMING PROCEDURES
      • INPUT SHAFT/MAINSHAFT & COUNTERSHAFT
      • COUNTERSHAFT EXTENSION
    • 4.7 TRANSMISSION REASSEMBLE
      • GEAR TRAINS AND SHIFT RAILS
      • TRANSMISSION CASE
      • COUNTERSHAFT EXTENSION ASSEMBLY
      • 5TH/6TH DRIVEN GEAR
      • REVERSE SYNCHROMESH ASSEMBLY
      • REVERSE SPEED GEAR
      • SPEEDOMETER PULSE RING
      • EXTENSION HOUSING
      • CLUTCH HOUSING AND SLAVE CYLINDER
  • 5. DIAGNOSIS
    • 5.1 TRANSMISSION SHIFTS HARD
    • 5.2 TRANSMISSION HARD TO SHIFT INTO REVERSE
    • 5.3 GEAR CLASH WHEN SHIFTING GEARS
    • 5.4 TRANSMISSION NOISY
    • 5.5 TRANSMISSION JUMPS OUT OF GEAR
    • 5.6 TRANSMISSION DOES NOT SHIFT INTO ONE GEAR
    • 5.7 TRANSMISSION LOCKED IN ONE GEAR
  • 6. SPECIFICATIONS
  • 7. TORQUE WRENCH SPECIFICATIONS
  • 8. SPECIAL TOOLS