holden.wiki

• MODEL SELECTION INDEX
• MY 2003 VY & V2 II SERIES - SERVICE INFORMATION
• SECTION 4B - FINAL DRIVE AND DRIVE SHAFTS
  • 1. GENERAL DESCRIPTION
    • 1. 1 FINAL DRIVE ASSEMBLY IDENTIFICATION
    • 1.2 FINAL DRIVE ASSEMBLY MAINTENANCE
      • MAINTENANCE
      • LIMITED SLIP DIFFERENTIAL PRECAUTIONS
      • LUBRICATION
  • 2. MINOR SERVICE OPERATIONS
    • 2.1 GENERAL
      • IMPORTANT SERVICE REQUIREMENTS
    • 2.2 CHECKING DIFFERENTIAL CARRIER LUBRICANT LEVEL
    • 2.3 CHANGING/FLUSHING REAR AXLE LUBRICANT
    • 2.4 TRAILING ARM TRUNNION ASSEMBLY HUB
      • CHECK FOR RUN-OUT
    • 2.5 TRAILING ARM TRUNNION ASSEMBLY HUB STUDS
      • REPLACE
    • 2.6 LIMITED SLIP DIFFERENTIAL
      • TORQUE CHECK
    • 2.7 DRIVE SHAFT ASSEMBLY
      • REMOVE
      • REINSTALL
    • 2.8 DRIVE SHAFT AND/OR CONSTANT VELOCITY JOINTS
      • DISASSEMBLE
      • INSPECT
      • REASSEMBLE
    • 2.9 INNER AXLE SHAFT SEAL
      • REPLACE
    • 2.10 PINION OIL SEAL
      • REPLACE
    • 2.11 PINION FLANGE
      • REPLACE (USING OLD OIL SEAL)
      • REPLACE (USING NEW OIL SEAL)
  • 3. MAJOR SERVICE OPERATIONS
    • 3.1 TRAILING ARM TRUNNION FLANGE, TRUNNION ASSEMBLY AND/OR WHEEL BEARING
      • REMOVE
      • REINSTALL
    • 3.2 FINAL DRIVE ASSEMBLY
      • REMOVE
      • REINSTALL
    • 3.3 REMOVED FINAL DRIVE ASSEMBLY
      • DISASSEMBLE
      • INSPECT
      • REASSEMBLE
    • 3.4 LIMITED SLIP DIFFERENTIAL
      • DISASSEMBLE
      • INSPECT
      • REASSEMBLE
    • 3.5 REAR AXLE
      • REASSEMBLE
  • 4. DIAGNOSIS
    • 4.1 GENERAL INFORMATION
    • 4.2 FINAL DRIVE ASSEMBLY NOISE
      • GEAR RELATED NOISE
      • BEARING RELATED NOISE
    • 4.3 LSD NOISE
    • 4.4 FINAL DRIVE BEARING DIAGNOSIS
  • 5. SPECIFICATIONS
  • 6. TORQUE WRENCH SPECIFICATIONS
  • 7. SPECIAL TOOLS