holden
.wiki
Home
Main Menu
Home
Main Menu
MODEL SELECTION INDEX
YG CRUZE
SECTION 8G - IMMOBILISER CONTROL SYSTEM
1. GENERAL DESCRIPTION
1.1 WIRING DIAGRAM
1.2 ON-BOARD DIAGNOSTIC SYSTEM (SELF-DIAGNOSIS FUNCTION)
2. DIAGNOSIS
2.1 PRECAUTIONS IN DIAGNOSING TROUBLES
PRECAUTIONS IN IDENTIFYING DIAGNOSTIC TROUBLE CODE
INTERMITTENT FAULTS
2.2 DIAGNOSTIC FLOW TABLE
2.3 DIAGNOSTIC TROUBLE CODE (DTC) CHECK (IMMOBILISER CONTROL MODULE)
USING TECH 2
2.4 DIAGNOSTIC TROUBLE CODE (DTC) CHECK (ECM)
USING TECH 2
NOT USING TECH 2
2.5 DIAGNOSTIC TROUBLE CODE TABLE
IMMOBILISER CONTROL MODULE
ECM
2.6 TABLE A - DTC IS NOT OUTPUT FROM IMMOBILISER CONTROL MODULE
WIRING DIAGRAM
INSPECTION
2.7 DTC11/32 TRANSPONDER CODE NOT MATCHED
DESCRIPTION
INSPECTION
2.8 DTC31 TRANSPONDER CODE NOT REGISTERED
DESCRIPTION
INSPECTION
2.9 DTC12 FAULT IN IMMOBILISER CONTROL MODULE
DESCRIPTION
INSPECTION
2.10 DTC13 NO TRANSPONDER CODE TRANSMITTED OR COIL ANTENNA OPENED / SHORTED
WIRING DIAGRAM
DESCRIPTION
INSPECTION
2.11 DTC21 ECM/IMMOBILISER CONTROL MODULE CODE NOT MATCHED (IMMOBILISER CONTROL MODULE SIDE)
2.12 DTC81 P1623 ECM/IMMOBILISER CONTROL MODULE CODE NOT MATCHED (ECM SIDE)
2.13 DTC84 P1620 ECM/IMMOBILISER CONTROL MODULE CODE NOT REGISTERED
DESCRIPTION
INSPECTION
2.14 DTC P1622 FAULT IN ECM
DESCRIPTION
INSPECTION
2.15 DTC22 IGNITION SWITCH CIRCUIT OPEN/SHORT
WIRING DIAGRAM
DESCRIPTION
INSPECTION
2.16 DTC23 NO ECM/IMMOBILISER CONTROL MODULE CODE TRANSMITTED FROM ECM OR DLC CIRCUIT OPENED/...
2.17 DTC83 (P1621) NO ECM/IMMOBILISER CONTROL MODULE CODE TRANSMITTED FROM IMMOBILISER CONTROL ...
WIRING DIAGRAM
DESCRIPTION
INSPECTION
2.18 INSPECTION OF ECM, IMMOBILISER CONTROL MODULE AND ITS CIRCUIT
VOLTAGE CHECK
3. ON-VEHICLE SERVICE
3.1 PRECAUTIONS IN HANDLING IMMOBILISER CONTROL SYSTEM
3.2 IMMOBILISER CONTROL MODULE
REMOVAL
INSTALLATION
4. IMMOBILISER FUNCTIONS
5. HOW TO REGISTER IGNITION KEY
6. PROCEDURE AFTER IMMOBILISER CONTROL MODULE &/OR ENGINE CONTROL UNIT REPLACEMENT
7. SPECIAL TOOLS
